Journal of Engineering Science and Technology (JESTEC)

Home Editorial Board Submit a paper Indexing and Awards Reviewers Publication Ethics Archives

Archive Special Issue on Development of Sustainability Systems - I. Collected articles of researches contributed to the SDGs identified by the UNDP, particularly on SDGs 6, 7, 9, 11, and 13. Pages 1 - 337 The Editor-in-Chief of this issue ● Professor Dr. Hussain H. Al-Kayiem Hilla University College, 51001 Ranjia, Babylon, Iraq. Director of Academic and Research Services (ACARES) Sdn. Bhd. - Malaysia prof.hussain@acaress.org; hhalkayiem51@gmail.com Editors ● Assoc. Prof. Dr. Hasanain A. Abdul Wahhab Training and workshop center, University of Technology, 35050 Karada, Baghdad, Iraq. 20085@uotechnology.edu.iq ● Assoc. Prof. Dr. Raed A. Jessam Electromechanical Engineering Department, University of Technology, 35050 Karada, Baghdad, Iraq. 50097@uotechnology.edu.iq Numerical analysis of wind turbine blades manufactured from composite materials at different velocities and arrangements H. M. Jaber, O. A. Shams, H. S. Majdi, A. R. Abdullah, L. J. Habeeb 1 - 17 Performance assessment of ejector refrigeration system under various operating conditions A. Al-Ezzi, H. H. Rahman, H. A. Abdul Wahhab 18 - 32 Mechanical vibration influence in microstructural alterations and mechanical properties of 304 stainless steel weld joints D. S. Dauod, M. S. Mohammed, I. A.A. Aziz, A. S. Abbas 33 - 54 Experimental investigation of PV/T solar collector efficiency with spherical-shaped protrusions on the absorber surface M. G. Ajel, E. Gedik, H. A. Abdul Wahhab, L. A.A. Mahdi, M. T. Chaichan 55 – 64 Influence nickel addition and heat treatment on mechanical properties and microstructure of aluminium alloy 6063 S. H. Omran, A. D. Assi, A. A. Shandookh, K. J. Mohammed 65 – 75 Enhanced fault detection and classification in transmission lines using fine-tuned lstm model and dbn transform-based feature selection M. Al Sultan, İ. Avci, O. Talab 76 -94 Prediction of premixed flames characteristics of liquefied petroleum gas (LPG) / hydrogen gas mixtures R. M. Ghazal, A. Akroot, H. A. Abdul Wahhab 95 - 104 A novel method of porous media simulation in open-flow pv/t collector using digital image processing T. N. Al-Bayati, N. I. B. Om, H. A. Abdul Wahhab, F. B. Ismail 105 - 116 Numerical simulation of a porous media solar collector integrated with thermal energy storage system M. Y. Nawaf, A. Akroot, H. A. Abdul Wahhab 117 – 130 Numerical and experimental assessment and analysis of a diffuser-augmented wind turbine M. M. Naji, B. A. Jabbar, M. A. Almaliki 131 – 143 Experimental study of strengthened reinforced concrete flat plate using cfrp under concentrated static loads B. R. Abed, S. Beddu, Z. Itam, M. A.A. Khudhair 144 - 162 Numerical analysis of the steam turbine performance in power station with a low power cycle M. Bdaiwi, A. Akroot, H. A. Abdul Wahhab, I. Mahariq 163 – 177 Solar photothermic conversion by wasted tire crumbs for water heating under the circular economy perspective H. H. Al-Kayiem, Sinan S. Hamdi, O. T. Lekan 178 – 193 Enhancing forced convective heat transfer in a sinusoidal duct by insertion of porous material M. S. Kassim, M. S. Sadeq, H. S.S. Aljibori, R. A. Mahmood 194 – 209 Potential of solar energy utilization using concentrated solar technique for power generation in Libya and transmission to Italy H. S. Majdi, M. Elmnifi, R. G. Rahel, A. R. Abdullah, L. J. Habeeb 210 – 224 Evaluation of electroplating effects on mechanical properties and fatigue of AA7075-T6 alloy S. H. Omran, A. A. Shandook, M. H. Ali, H. A. Abdul Wahhab 225 – 239 Fatigue and hardness behavior of AL-2CU-2MG alloy due to titanium dioxide and silicon carbide nanoadditives S. H. Omran, A. D. Assi, M. H. Ali., A. A. Shandook, L. H. Abbud, H. A. Abdul Wahhab 240 – 254 Mathematical modeling and evaluation of fuel injection pressure effects on the performance and emissions of gasoline direct injection engine O. M. Yousif, M. A. Mashkour 255 – 274 Experimental and numerical investigation of flow maldistribution in a circular microchannel heat exchanger at various flowrates A. D.J. Al-Bayati, H. A. Abdul Wahhab, H. H. Al-Kayiem, I. M. Mohamed 275 – 287 Experimental evaluation of climate parameters impact on grid-connected PV electricity generation: a practical approach A. O. Abd, T. M.A. Al-Nasser, N. S. Ekaab, W. H. Alawee, H. A. Kazem, M. T. Chaichan 288 – 306 Experimental evaluation of the combustion and emission characteristics of waste non-edible restaurant oils and high-sulfur Diesel M. T. Chaichan, N. S. Ekab, I. E. Yousif 307 – 322 Exploration of the effect of the pendulum and perpendicular mass movement on the spring-mass in static and dynamic conditions using MEMS N. Y. Jasim, T. K. Salman, M. M. Al-Azzawi, H. S. Majdi, L. J. Habeeb 323 – 337

Home

Editorial Board

Submit a paper

Indexing and Awards

Reviewers

Publication Ethics

Archives

Copyright ©2006-2025 by: School of Engineering. Taylor’s University